Accessories

The RFID Card Reader is used to identify driver staff by reading the ID codes of RFID cards. The identifier allows you to control the actuator (electronic lock, valve, etc.) using the built-in key element if the current card code and the code in the internal card database match.

The reader can be used both as a part of the RFID system and as a separate device. Can be easily connected/integrated with 3rd part GPS devices.

Supported interfaces: RS-232, RS-485, 1-Wire

Working standards: EM-Marin 125 kHz, ISO14443A (MIFARE) 13,56 MHz

 Galvanic stabilizer is used for isolating the power supply system GPS-tracker, fuel level sensors and other devices. The stabilizer provides galvanic isolation of power chains and hardware. Applied when necessary to provide power if you disable the «masses».

The stabilizer provides protection against conducted interference of the 4th degree of hardness to board a 12 V, and third degrees for 24 V. Provides functional class «C» (it self-renews after prolonged exposure to stress from −1000 V to +160 V) and a class «A» (work without interruption in the voltage range 12–40 V and pulsed exposures of +40 V to +160 V for up to 0.5 sec).

Digital fuel level indicator is installed on the dashboard of your vehicle and designed for permanent visual control of fuel volume in the tank by the driver. Digital fuel level indicator is connected to digital fuel level sensor, and indicates measured level via RS-232 or RS-485 digital interfaces. The device can operate both in passive mode (along with GPS tracking device which reads data from fuel level sensor) and in active mode, sending requests to sensor independently. Sensor has “filling” mode, which allows to control volume of fuel, filled in vehicle tank. Indicators weight does not exceed 90g.

Frequency-to-voltage converter FV-1x  is designed for precise linear conversion of variable-frequency output signal of EPSILON ES2, EN2 fuel level sensor into analog (voltage) signal for vehicle monitoring devices (trackers) to monitor the level of fuel.

A digital temperature and humidity sensor with RS-485 or RS-232 interface, designed for use in refrigerator temperature control systems. The sensor requires no calibration during installation.

Its hermetically sealed design ensures resistance to aggressive detergents commonly used for refrigerator disinfection.

Measurement accuracy: ±0.5 °C.

Wireless identification of trailing equipment and attached implements by the wireless identifier is intended to monitor remote equipment.
It can be used with agricultural machinery and automotive transport. Special reader is used to receive ID-codes of the identifier.
Can be connected to any GPS tracking device.